This innovative approach will solve the following issues caused by using DIP type of components:
Hard to read the value (Resistor color codes)
Severe deformations of the pin after used, non-reusable, not environment-friendly
The pin diameter is too thin or too thick, poor match with the breadboard hole
Confused the order of transistor “e”, “b”, “c” pins
Usage problem: Most of sensors and actuators require 3 interfaces: Signal/VCC/GND, you have to use the jumper wire for the connection, messy and unreliable.
SPECIFICATION
Resistor: 220R,1K,4.7K,10K
Capacitor: 22pF@50V,100nF(0.1uF)@50V,47uF@10V
LED: Red, Yellow, Blue, Green
Diode: If=1A, Vfm=0.7V, Vr=40V
Transistor-NPN: Vceo=45V, Ic=500mA, hFE=400
Transistor-PNP: Vceo=-45V, Ic=-500mA, hFE=400
RESSOURCES
wiki doc
SHIPPING LIST
Resistor 220R x4
Resistor 1K x4
Resistor 4.7K x4
Resistor 10K x4
Capacitor 22pF x2
Capacitor 100nF x2
Capacitor 47uF x2
LED--R x2
LED--Y x2
LED--B x2
LED--G x2
Diode x4
NPN transistor x2
PNP transistor x2
Breadboard PluginConnector x2