This compact, cost-effective optical quadrature encoder can be attached to the 4 mm wall of a motor. It has 300 cycles (full quadrature cycles) per revolution and can be installed by mounting it over the shaft, attaching it to the side of the motor and tightening the adjusting screw. For complete mounting instructions, refer to the operating instructions. This encoder does not support the use of an index channel.
Product specifications
Encoder characteristics:
- Control via encoder interface
- Output circuit type Push-pull (one-sided)
- Encoder speed Max. 6000 rpm
- Encoder resolution 300 CPR
>Electrical characteristics:
- Supply voltage min. 5 V DC
- Supply voltage max. 5 V DC
- Output frequency Max. 30 kHz
- Physical properties:
- Inner diameter 4 mm
- Operating humidity Min. 30 %RH
- Operating humidity Max (non-condensing) 85 %RH
- Operating temperature Min -10 °C
- Operating temperature Max. 85 °C
- IP protection IP40
- Weight 4 g
Scope of delivery:
- Cable for the HKT encoder
- 0.9 mm Allen key for adjusting screws
- Encoder cap and holder made of plastic
- Encoder plate
- Encoder board
- Two screws
| Shipping weight: | 0,05 Kg |
| Product weight: | 0,02 Kg |
